Can-Am DS 450 2008 Shop Manual page 93

STATOR CONTINUITY TEST AT STATOR
CONNECTOR
TEST PROBES
YELLOW and
BLACK/YELLOW wires
YELLOW and BLACK
wires
BLACK and
BLACK/YELLOW wires
If a resistance reading is not as specified, replace
the stator.
If resistance readings are good at the stator con-
nector but not at the voltage regulator/rectifier
connector, repair or replace the rear main harness
wiring as required.
Stator Insulation Test
Test at Voltage Regulator/Rectifier Connector
Disconnect the voltage regulator/rectifier connec-
tor.
vmr2008-025-008_a
1. Disconnect voltage regulator/rectifier connector
Set multimeter to .
Connect multimeter between any YELLOW wire
and chassis ground.
vmr2008-015
RESISTANCE @
20°C (69°F)
0.1 - 1
Subsection 06 (MAGNETO/STARTER)
vmr2008-025-009_b
STATOR INSULATION TEST AT VOLTAGE
REGULATOR/RECTIFIER CONNECTOR
Read resistance.
STATOR INSULATION TEST AT VOLTAGE
REGULATOR/RECTIFIER
PROBE POSITIONS
Any YELLOW wire and
chassis ground
If there is a resistance or continuity, repeat test at
stator connector.
Test at Stator Connector
Disconnect the stator connector and install the
three pin stator harness adaptor as in the previ-
ous stator continuity test.
vmr2008-025-015_a
1. Adapter connected to stator harness only
2. Rear main harness not connected to adapter
Repeat stator insulation test measuring the resis-
tance between each adaptor wire and ground.
Section 03 ENGINE
RESISTANCE @
20°C (69°F)
Infinity (open circuit)
73