Can-Am DS 450 2008 Shop Manual page 361

vmr2008-033-030_a
1. Brake light switch connector
2. Air filter housing
Drain brake fluid from rear brake circuit. See
BRAKE FLUID DRAINING
section.
Unscrew brake light switch and discard the sealing
washers.
vmr2008-033-031_a
1. Brake light switch
2. Sealing washers
NOTE: At this time, check hoses and fittings for
damages or leaks.
Remove the brake pedal spring.
vmr2008-033-032_a
1. Brake pedal spring
Remove pin securing brake pedal to master cylin-
der rod hook. Discard the cotter pin.
vmr2008-033
at the beginning of this
Section 08 CHASSIS
Subsection 05 (BRAKES)
vmr2008-033-033_a
1. Cotter pin (discard)
2. Brake pedal
3. Retaining pin
4. Hook
Disconnect reservoir hose from master cylinder.
Remove bolts retaining master cylinder to frame.
vmr2008-033-034_a
1. Master cylinder bolts
2. Master cylinder
3. Reservoir hose
Rear Master Cylinder Disassembly
Remove hook from master cylinder rod.
vmr2008-033-035_a
1. Hook
2. Locking nut
3. Master cylinder rod
Remove and discard boot.
NOTE: The base of boot is deformed during re-
moval. For optimal sealing, the replacement of
the boot is necessary.
341