MSD-72 Series User's Guide
9.14.5 Display position
Top → BITMAP → POSITION
Menu
Setting for
Each output channel, each bitmap
Setting value [Figure 9.30] Display position
●
You can set the display position of the bitmap.
9.14.6 Input channel assignment
Top → BITMAP → CHANNEL ASSIGN
Menu
Setting for
Each input channel, each output channel
Setting value OFF [Default], ON (BITMAP1 ON to BITMAP4 ON)
A bitmap can be treated as an input video source by assigning the bitmap to any input that is not currently
being used. Set "9.14.2 Outputing bitmap image" to "OFF".
If multiple bitmaps are registered, select the bitmap number to be output.
If you switch a normal image to a bitmap image, it takes longer time to output the image, and you cannot
perform other operations while the bitmap is being written and displayed.
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.
9.14.7 Bitmap output at startup
Top → BITMAP → POWER ON BITMAP
Menu
Setting for
Each output channel
Setting value OFF [Default], ON (BITMAP1 ON to BITMAP4 ON)
You can enable or disable bitmap output at the time of the MSD startup.
120
●
TOP-LEFT
CENTER
[Default]
●
BOTTOM-LEFT
[Figure 9.30] Display position
●
TOP-RIGHT
●
BOTTOM-RIGHT