Mounting; Electromagnetic Compatibility; Wiring Requirement Of Installation Site - MR ECOTAP VPD CONTROL PRO Operating Instructions Manual

DANGER
WARNING
NOTICE
® ®
32 ECOTAP VPD CONTROL PRO

6 Mounting

The following description does not apply if you have ordered the device ver-
sion with control cabinet. If that is the case, follow the description in the
ECOTAP VPD MD&C operating instructions.
This chapter describes how to correctly install and connect the device. Ob-
serve the connection diagrams provided.
Electric shock!
Risk of fatal injury due to electrical voltage. Always observe the following
safety regulations when working in or on electrical equipment.
► Disconnect the equipment.
► Lock the equipment to prevent an unintentional restart.
► Make sure all poles are de-energized.
► Ground and short-circuit.
► Cover or cordon off adjacent energized parts.
Electric shock!
Dangerous high voltages may occur when a current transformer is operated
with an open secondary circuit. This can lead to death, injuries and property
damage.
► Never operate a current transformer with an open secondary circuit;
short-circuit the current transformer to prevent this.
► Observe the information in the current transformer operating instructions.
Damage to the device!
Electrostatic discharge may cause damage to the device.
► Take precautionary measures to prevent the build-up of electrostatic
charges on work surfaces and personnel.

6.1 Electromagnetic compatibility

The device has been developed in accordance with applicable EMC stan-
dards. The following points must be noted in order to maintain the EMC
standards.

6.1.1 Wiring requirement of installation site

Note the following when selecting the installation site:
▪ The system's overvoltage protection must be effective.
▪ The system's ground connection must comply with all technical regula-
tions.
5252433/02 EN
6 Mounting
Maschinenfabrik Reinhausen GmbH 2018