Configuring Dnp3 (Optional) - MR ECOTAP VPD CONTROL PRO Operating Instructions Manual

8.11.5 Configuring DNP3 (optional)

® ®
126 ECOTAP VPD CONTROL PRO
To activate/deactivate the "TCP Keepalive" function, proceed as follows:
1. Go to Settings > Parameters > Modbus > TCP Keepalive.
2. Select the desired option.
3. Press the Accept button to save the modified parameter.
IP address
You can use this parameter to assign an IP address to the device.
Assign IP addresses to both web-based visualization and SCADA (optional)
in different subnets. Otherwise you will not be able to establish a connec-
tion.
1. Go to Settings > Parameters > Modbus > IP address.
2. Enter the IP address.
3. Press the Accept button to save the modified parameter.
If you would like to use the DNP3 control system protocol, you must set the
parameters listed below.
The device only supports DNP3 TCP.
Figure 82: Setting parameters for DNP3
IP address
You can use this parameter to assign an IP address to the device.
5252433/02 EN
8 Operation
Maschinenfabrik Reinhausen GmbH 2018