MR ECOTAP VPD CONTROL PRO Operating Instructions Manual page 65

7 Commissioning
7.3.2.3 Setting further parameters
Maschinenfabrik Reinhausen GmbH 2018
The time does not switch from daylight saving time to standard time and
back automatically.
Proceed as follows to set the date and time manually:
1. Go to Settings > Time.
Figure 50: Setting date and time
2. Enter date and time.
3. Press the Accept button to save the modified parameter.
Set further parameters to commission the device. You will find more detailed
information about the respective parameters in the Operation [►Section 8,
Page 66] chapter.
1. Activate ECOTAP VPD communication [►Section 8.3, Page 70].
2. Set transformer data [►Section 8.5, Page 81].
3. Set control parameters [►Section 8.4, Page 71].
4. Set control system protocol (optional) [►Section 8.11, Page 119].
5252433/02 EN
® ®
ECOTAP VPD CONTROL PRO 65