MR ECOTAP VPD CONTROL PRO Operating Instructions Manual page 172

® ®
172 ECOTAP VPD CONTROL PRO
Parameters
Target-tap-position operation
Activate desired value 1
Activate desired value 2
Activate desired value 3
Activate desired value 4
Activate desired value 5
Increase desired value
Decrease desired value
Table 62: Functions available
Figure 108: Linking functions
In order to establish the link, you have to enter the corresponding event
number in the desired parameter.
Note that you can only enter the event numbers of the Generic SCADA
command events.
If you enter event number 500, the link is disabled.
5252433/02 EN
Description
If the assigned event is active, the device
switches to the defined target tap posi-
tion.
If the assigned event is active, the device
activates desired value 1.
If the assigned event is active, the device
activates desired value 2.
If the assigned event is active, the device
activates desired value 3.
If the assigned event is active, the device
activates desired value 4.
If the assigned event is active, the device
activates desired value 5.
If the assigned event is active, the device
prompts an increase in the desired
value.
If the assigned event is active, the device
prompts a decrease in the desired value.
Maschinenfabrik Reinhausen GmbH 2018
8 Operation