MR ECOTAP VPD CONTROL PRO Operating Instructions Manual page 125

8 Operation
Maschinenfabrik Reinhausen GmbH 2018
Figure 81: Setting parameters for Modbus
Modbus address
You can use this parameter to set the Modbus address.
To set the Modbus address, proceed as follows:
1. Go to Settings > Parameters > Modbus > Modbus address.
2. Enter the Modbus address.
3. Press the Accept button to save the modified parameter.
TCP port
You can use this parameter to set the TCP port.
To set the TCP port, proceed as follows:
1. Go to Settings > Parameters > Modbus > TCP port.
2. Enter the TCP port.
3. Press the Accept button to save the modified parameter.
Maximum TCP connections
You can use this parameter to set the maximum number of TCP connec-
tions.
To set the maximum number of TCP connections, proceed as follows:
1. Go to Settings > Parameters > Modbus > Maximum TCP connections.
2. Enter the maximum number of TCP connections.
3. Press the Accept button to save the modified parameter.
TCP Keepalive
You can use this parameter to activate/deactivate the "TCP Keepalive" func-
tion.
5252433/02 EN
® ®
ECOTAP VPD CONTROL PRO 125