MR ECOTAP VPD CONTROL PRO Operating Instructions Manual page 73

8 Operation
Maschinenfabrik Reinhausen GmbH 2018
P Active power at minimum de-
min
sired value
P Active power at maximum de-
max
sired value
Response to active power P
If the measured active power P
U is adopted as the desired value.
max
Response to value falling below active power P
If the measured active power P
value U is adopted as the desired value.
min
Response to a measured active power P
If the measured active power P
Linear dependency with negative active power:
If the measured active power P
using the following formula:
Linear dependency with positive active power:
If the measured active power 0 ≤ P
using the following formula:
5252433/02 EN
U Set desired value when mea-
0
sured active power = 0
being exceeded
max
exceeds the set parameter P
meas
min
falls below the set parameter P
meas
= 0 MW:
meas
= 0, the set parameter U
meas
≤ P ≤ 0, the desired value is calculated
min meas
≤ P , the desired value is calculated
meas max
® ®
ECOTAP VPD
, the value
max
, the
min
is adopted.
0
CONTROL PRO 73