Measurement; Setting Ui Measuring Channels - MR ECOTAP VPD CONTROL PRO Operating Instructions Manual

8 Operation
Maschinenfabrik Reinhausen GmbH 2018
Setting phase angle correction
You can use this parameter to set the phase angle correction for your trans-
former circuit. To do so, proceed as follows:
1. Go to Settings > Parameters > Transformer data > Phase angle cor-
rection.
2. Select the desired option.
3. Press the Accept button to save the modified parameter.
Setting measurement mode
If you are measuring the voltage and current with the 3-phase UI 3 measur-
ing module, you can use this parameter to set whether you have connected
the voltage transformer between 2 phases or between a phase and neutral.
To set the measuring mode, proceed as follows:
1. Go to Settings > Parameters > Transformer data > Measuring mode.
2. Select the option you want.
3. Press the Accept button to save the modified parameter.
Also refer to
2 Setting UI measuring channels [► 91]

8.6 Measurement

8.6.1 Setting UI measuring channels

If you are measuring the voltage and current with the 3-phase UI 3 measur-
ing module, you can use this parameter to set the measurement channels in
use:
Option
1-ph. measurement: Channel 1
3-ph. measurement: Channel 1,
2, 3
3-ph. voltage, 1-ph. current
Table 29: UI measuring channels
To set the UI measuring channels, proceed as follows:
1. Go to Settings > Parameters > Measurement > UI measuring chan-
nels.
2. Select the option you want.
3. Press the Accept button to save the modified parameter.
5252433/02 EN
Description
The device uses 1 channel each for measure-
ment of voltage and current.
The device uses 3 channels each for measure-
ment of voltage and current.
The device uses 3 channels for voltage measure-
ment and 1 channel for current measurement.
® ®
ECOTAP VPD CONTROL PRO 91