Table of Contents
Advertisement
Fast commissioning / operating principle
3
Fast commissioning / operating principle
Below you will find a short description for the initial commissioning of the
BCL 500
i
\ BCL 501
technical description.
3.1
Mounting the BCL 500
The BCL 500
• Using two M4x6 screws on the rear of the device or using four M4x6 screws on the
bottom of the device.
• Using a BT 56 mounting device on the two fastening grooves.
3.2
Device arrangement and selection of the mounting location
In order to select the right mounting location, several factors must be considered:
• Size, orientation, and position tolerance of the barcodes on the objects to be
scanned.
• The reading field of the BCL 500
• The resulting minimum and maximum reading distance from the respective reading
field (see chapter 5.5 "Reading field curves / optical data").
• The permissible line lengths between the BCL 500
depending on which interface is used.
• The correct time for data output. The BCL 500
such a way that, taking into consideration the time required for data processing and
the conveyor belt speed, there is sufficient time to e.g. initiate sorting operations on
the basis of the read data.
• The display and control panel should be very visible and accessible.
• For configuring and commissioning with the webConfig tool, the USB interface should
be easily accessible.
For specific information, please refer to chapter 4.4.
Notice!
The beam exits the BCL
- line scanner parallel to the housing base
- oscillating mirror and deflection mirror perpendicular to the housing base
The black areas in figure 6.1 are the housing base. The best read results are obtained when:
• The BCL 500
dent on the barcode at an angle of inclination greater than ±10° ... 15° to vertical.
• The reading distance lies in the middle area of the reading field.
• The barcode labels are of good print quality and have good contrast ratios.
• You do not use high-gloss labels.
• There is no direct sunlight.
14
i
. Detailed explanations for all listed points can be found throughout this
i
\ BCL 501
i
i
\ BCL 501
barcode readers can be mounted in two different ways:
500i
\ BCL
i
i
\ BCL 501
is mounted in such a way that the scanning beam is inci-
BCL 500
i
i
i
\ BCL 501
in relation to the barcode module width.
i
i
\ BCL 501
501i
as follows for the respective devices:
i
i
\ BCL 501
\ BCL 501
i
and the host system
i
should be positioned in
Leuze electronic
Advertisement
Table of Contents
