Commissioning; Measures To Be Performed Prior To The Initial Commissioning; Function Test - Leuze electronic BCL 8 Series Original Operating Instructions

7

Commissioning

ATTENTION, LASER RADIATION – CLASS 2 LASER PRODUCT
Follow the safety notices in Chapter 2.5 on Page 7!
7.1

Measures to be performed prior to the initial commissioning

 Before commissioning, familiarize yourself with the operation and configuration of the
device(s).
 Before connecting the supply voltage, recheck all connections and ensure that they have
been properly made.
7.2

Function Test

"Power On" test
After connecting the operating voltage, the BCL 8 performs an automatic "Power On" func-
tion test. Afterward, the green status LED on the top side of the BCL 8 lights up. Only then
are any saved customer-specific settings active.
Interface
Proper function of the interface can be tested easiest in service operation using the service
interface with the "BCLConfig" programming software and a notebook computer.
Online commands
Using the online commands, important device functions can be checked, e.g. proper func-
tioning of the laser.
Problems
Should problems occur during device commissioning, refer first to Chapter 8.2. If a problem
occurs that cannot be rectified even after checking all electrical connections and settings on
the devices and on the host, please contact the closest Leuze service organization (see
back page of this operating manual).
Leuze electronic BCL 8
Commissioning
39