Table of Contents
Advertisement
Fast commissioning / operating principle
3.5
Barcode reading
With the aid of the "Action menu", you can instruct the BCL 500
barcode.
Actions
o Start decoding
o Start alignment
o Start auto-setup
o Start teach-in
To test, you can use the following barcode in the 2/5 Interleaved format. The barcode
module here is 0.5:
The read information appears in the display and is simultaneously passed on to the primary
system (PLC or PC).
Please check the incoming data of the barcode information there.
Alternatively, you can connect a photoelectric sensor or a 24 V DC switching signal to the
SW IN/OUT socket for read activation. To do this, however, you must appropriately
configure the switching input (see chapter 7.2.3 "SW IN/OUT – Switching input/switching
output").
18
In the main menu, use the
Actions menu item. Activate the Actions menu with
Then select Start decoding with
again to start the barcode reading operation.
Modul 0,5
6677889900
i
BCL 500
\ BCL 501
i
\ BCL 501
buttons to select the
i
i
to read a
.
and press
Leuze electronic
Advertisement
Table of Contents
