Table of Contents
Advertisement
Installation and mounting
Figure 6.4:
Notice!
When mounting, ensure that the scanning beam is not reflected directly back to the scanner
by the label which is being read. For further information, see the notices in chapter 6.3!:
Please refer to chapter 5.6 for the permissible minimum and maximum distances between
the BCL
500i
6.3
Device arrangement
6.3.1
Selecting a mounting location
In order to select the right mounting location, several factors must be considered:
• Size, orientation, and position tolerance of the barcodes on the objects to be
scanned.
• The reading field of the BCL 500
• The resulting minimum and maximum reading distance from the respective reading
field (see chapter 5.5 "Reading field curves / optical data").
• The permissible line lengths between the BCL 500
depending on which interface is used.
• The correct time for data output. The BCL 500
such a way that, taking into consideration the time required for data processing and
the conveyor belt speed, there is sufficient time to e.g. initiate sorting operations on
the basis of the read data.
• The display and control panel should be very visible and accessible.
• For configuring and commissioning with the webConfig tool, the USB interface should
be easily accessible.
For specific information, please refer to chapter 4.4.
66
Mounting example BCL 500
\ BCL
501i
and the labels to be read.
BCL 500
i
\ BCL 501
i
i
\ BCL 501
i
in relation to the barcode module width.
i
\ BCL 501
i
\ BCL 501
i
i
\ BCL 501
i
and the host system
i
should be positioned in
Leuze electronic
Advertisement
Table of Contents
