Table of Contents
Advertisement
Commissioning and configuration
Parameter
Parameter handling
Decoder table
Digital SWIO
o Com
Com
Operating mode
HOST / BUS IN
o BUS OUT
BUS OUT
multiNet master
o multiNet slave
multiNet slave
o Slave address
Slave address
1|
<-|0123456789
Standard
Notice!
Permissible values for the network address in the Leuze multiNet plus are 0 ... 31. Make
certain that a different address is assigned to each multiNet plus participant.
Notice!
From the hardware address (device address > 0), the BCL
required. It automatically switches to the Leuze multiNet plus network and waits for initiali-
sation by the master.
116
save
----- Unit
1
|
|
BCL 500
1
In the Parameter menu, use the
select the Com menu item.
Press the enter button to enter the Com menu.
Use the
buttons to select the BUS OUT menu
item.
Press the enter button to enter the BUS OUT menu.
Use the
buttons to select the multiNet slave
menu item.
Press the enter button to enter the multiNet slave
menu.
Press the
enter button to enter the menu for set-
ting the slave address.
Displayed in the following screen is the preset slave
address 1, which you can now change. Use the
and
buttons to set the desired slave address. An
accidental, incorrect entry can be corrected by
selecting
and then pressing
<-|
Then use the
the set slave address by pressing
i
i
\ BCL 501
buttons to
.
buttons to select save and save
.
501i
detects that networking is
Leuze electronic
Advertisement
Table of Contents
