Table of Contents
Advertisement
Determining parameter set difference to default parameters
Command
Description
Parameter
Acknowledge-
ment
positive
Leuze electronic
This command outputs the difference between the default parameter
set and the operating parameter set or the difference between the
default parameter set and the permanent parameter set.
Comment:
The reply supplied by this command can e.g. be directly used for pro-
gramming a device with factory settings, whereby this device receives
the same configuration as the device on which the PD-sequence was
executed.
'PD<P.set1><P.set2>'
<P.set1>
Parameter data set which is to be copied,
unit [dimensionless]
'0'
Parameter data set in permanent memory
'2'
Default or factory parameter set
<P.set2>
Parameter set to which the data is to be copied, unit
[dimensionless]
'0'
Parameter data set in permanent memory
'3'
Operating parameter data set in volatile memory
Permissible combinations here include:
'20'
Output of the parameter differences between the default
and the permanently saved parameter set
'23'
Output of the parameter differences between the default
parameter set and the operating parameter set saved in
volatile memory
'03'
Output of the parameter differences between the perma-
nent parameter set and the operating parameter set
saved in volatile memory
PT<BCC><PS type><Status><Adr.><P.value adr.><P.val-
ueAdr.+1>...
[;<Adr.><P.value adr.>]
<BCC>
'0'
No check digit
'3'
BCC mode 3
<PS type>
'0'
Values stored in flash memory
'3'
Operating values stored in RAM
<Status>
'0'
No further parameters
'1'
Additional parameters follow
<Adr.>
Relative address of the data within the data set
'aaaa'
Four-digit, unit [dimensionless]
<P.value> Parameter value of the -bb- parameter stored at this
address. The parameter set data is converted from HEX
format to a 2-byte-ASCII format for transfer.
i
BCL 500
'PD'
i
\ BCL 501
Online commands
135
Advertisement
Table of Contents
