Table of Contents
Advertisement
8.4
Operation
Shown here is an example describing important operating procedures in detail.
Parameter enabling
During normal operation parameters can only be viewed. If parameters need to be changed,
the ON menu item in the Parameter enabling menu must be activated. To do this proceed
as follows:
Parameter
Parameter handling
Decoder table
Digital SWIO
Com
Parameter handling
o Parameter enabling
Parameters to default
Parameter enabling
OFF
o ON
Standard ----- Unit
OFF
|
Parameter enabling
OFF
O ON
Standard ----- Unit
OFF
|
Network configuration
Information on network configuration can be found in chapter "Commissioning and configu-
ration" on page 109.
Leuze electronic
1
1.1
|
|
ESC
ESC
BCL 500
In the parameter menu, use the
Parameter handling menu item.
Press the enter button to enter the Parameter handling
menu.
In the Parameter handling menu, use the
select the Parameter enabling menu item.
Press the enter button to enter the Parameter enabling
menu.
In the Parameter enabling menu, use the
select the ON menu item.
Press the enter button to switch on parameter enabling.
The PWR LED lights up red. You can now set individual
parameters via the display.
Press the ESC button twice to return to the main menu.
i
i
\ BCL 501
Display and control panel
buttons to select the
buttons to
buttons to
103
Advertisement
Table of Contents
