Table of Contents
Advertisement
10.1.4 Selecting the operating mode
If you wish to operate the BCL 500
priate operating mode.
Via webConfig tool
Select the desired operating mode in the main menu Configuration, submenu Communi-
cation -> Overview.
Or, alternatively, via the display
In the main menu, use the
button
Parameter
Parameter handling
Decoder table
Digital SWIO
o Com
Com
o Operating mode
HOST / BUS IN
BUS OUT
Operating mode
o Stand-alone device
Network Master
Network Slave
webConfig tool or display
Select one of the following three operating modes:
• Stand-alone device:
BCL 500
• Network Master
BCL 500
operation. For further information, refer to chapter 10.1.5.
• Network Slave
BCL 500
tion. The configuration of the BCL 500
uration of the BCL 501
Leuze electronic
to activate the Parameter menu. The following screen appears:
1
In the Parameter menu, use the
Com menu item.
Press the enter button to enter the Com menu.
Use the
menu item.
Press the enter button to go to the selection of the Oper-
ating mode
Use the
press the enter button
i
in stand-alone operation. For further information, refer to chapter 10.3.
i
as a master in multiNet plus. Additional settings are required for master
i
as slave in multiNet plus. Additional settings are required for slave opera-
i
. For further information on this topic, refer to chapter 10.2.3.
BCL 500
Commissioning and configuration
i
as a multiNet master or slave, you must set the appro-
buttons to select the Parameter menu and use the enter
buttons to select the Operating mode
buttons to select the desired menu item and
i
as a multiNet slave corresponds to the config-
i
i
\ BCL 501
buttons to select the
to activate the operating mode.
111
Advertisement
Table of Contents
