Table of Contents
Advertisement
Display and control panel
Start auto-setup
The auto-setup function provides an easy option for configuring the code type and number
of digits of Decoder 1.
Use the
the reading beam of the BCL
The following display appears:
Actions
o Stop auto-setup
xx yy zzzzzz
The following information is displayed:
xx
'01'
'02'
'06'
'07'
'08'
'10'
'11'
yy
zzzzzz:
Start teach-in
The teach-in function can be used to conveniently read reference code 1.
Use the
the content that you wish to store as the reference code in the reading beam of the
BCL
500i
The following display appears:
Actions
o Stop teach-in
RC13xxzzzzzz
The following information is displayed:
RC13
xx
z
102
button to activate the auto-setup function and place an unknown barcode in
Code type of the detected code (sets the code type of Decoder 1)
2/5 Interleaved
Code 39
UPC (A, E)
EAN
Code 128, EAN 128
EAN/UPC
Codabar
Number of digits of the detected code (sets the number of digits of Decoder 1)
Contents of the decoded label. A ↑ appears if the label was not correctly read.
button to activate the teach-in function and place a barcode which contains
\ BCL 501i.
means that reference code number 1 is stored in RAM. This is always output.
defined code type (see auto-setup)
defined code information (1 ... 63 characters)
BCL 500
500i
\ BCL 501i.
i
i
\ BCL 501
Leuze electronic
Advertisement
Table of Contents
