Starting Or Stopping Setup Support From The Pda; User Interface Of The Pda - Siemens SIMATIC Vision Sensor VS 130-2 Manual

Operator Input
5.4.3

Starting or stopping setup support from the PDA

It is assumed that the connection between PDA and processing unit is established.
Proceed as follows:
1. Start the Internet Explorer on the PDA, enter the IP address in the "Address" input
box and then press "Enter".
The start page of the setup support appears.
2. Click on "Live image for PDA".
The user interface of the PDA for the VS 130-2/VS 130-2vcr appears.
Note
If you have started the user interface of the PDA, you can only run the setup
support from a PC/PG in read-only mode.
If you want to terminate the connection to the processing unit, turn off the PDA.
Closing the Internet Explorer does not terminate the connection.
5.4.4

User interface of the PDA

Overview
The user interface consists of the following elements:
•
Live image
•
Text display row
•
Operator input row with the mode button, the "Trg" trigger button (VS 130-2vcr
only) and the code selection.
Note
If there is a connection between the Web browser of a PC and the processing unit
or the VS 130-2/VS 130-2vcr is being controlled by an automation system, all
buttons are disabled and "(Read Only Mode)" is displayed in the text display row.
As long as no physical connection can be established to the processing unit,
"Connecting..." is displayed.
The labeling of the buttons and their function depend on the current status of the
VS 130-2/VS 130-2vcr. This also applies to the strings of the text display row. This
is explained in detail below.
5-50
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr
A5E00475759-01