As an example, you can see the "Adjust Sensor" dialog below.
Note
If the DISA bit is set, in other words, when VS 130-2/VS 130-2vcr is controlled by a
programmable controller, you must log on at the processing unit as follows:
1. Make sure that only one PC accesses the processing unit (red lock with
green D).
2. Place the mouse pointer on the currently logged-on user (top right) and click.
This brings you to the "Options Part 3/4: Security".
3. Log on as a user ("User1" or "Service") who is allowed to take control of the
VS 130-2/VS 130-2vcr ("Take control" check box selected). Remember,
however, that logging on accesses control of the VS 130-2/VS 130-2vcr by the
programmable controller (only relevant for functions that require the DISA bit,
for example, change codes and train code).
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr
A5E00475759-01
Operator Input
5-27