Siemens SIMATIC Vision Sensor VS 130-2 Manual page 66

Operator Input
Parameter
Save Next Diagnose>
(only for Logging>
VS 130-2) Report>
Permanent
Entries Diagnose>
(only for Logging>
VS 130-2) Report>
Permanent
Clear Diagnose>
(only for Logging>
VS 130-2) Report>
Permanent
Timebase Diagnose>
Logging
SNTP IP Diagnose>
Logging
(Only when
Timebase= SNTP)
Update Diagnose>
Monitor
Extras (only for VS 130-2)
Multi Extras>
Light
LightSrc. Extras>
Light
(Only if Multi= On)
5-22
Path Possible
Values
On, Off
10 to 2000
-
PC, SNTP
xxx.xxx.xxx.xxx
(xxx=0 to 255)
On
Off
On, Off
Lamp1, ...
Lamp4
Default setting
Off As soon as the function is enabled,
as many diagnostic entries as you
specify in "Entries" are saved in the
EPROM. Existing entries are deleted
when you switch over to On. If the
diagnostic buffer in the EPROM
reaches the number of permanently
storable diagnostic data records, no
further entries are made.
Note: Deleting takes several
seconds.
2000 Number diagnostic data records that
can be stored on the EPROM
- Delete all the diagnostic entries
stored on the EPROM
Note: Deleting takes several
seconds.
PC/ Here, you specify the source for the
time stamp of the diagnostic events.
192.168.000.044 IP address of the SNTP server
On Here, you specify whether images
and the events are saved in
processing mode and whether a live
image is displayed:
•
On: Images and events are
saved, live image
•
Off: Images and events are not
saved, no live image
•
Off On: Mode in which you specify
the lamp to be used for lighting.
In this mode, the result bits
cannot be output over the DI/DO
interface.
The information on which lamp
to use is stored along with the
code data.
When reading without previous
training (Code number=Auto),
the lamp currently set in the
parameters will be used.
Lamp1 Default lamp to be used for the
image capture
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr
Meaning
A5E00475759-01