Siemens SIMATIC Vision Sensor VS 130-2 Manual page 141

No. Signal Description
20 This will reset
If you connect a sensor with a resolution
settings! that does not match that of the previously
Ok connected sensor, the parameters will be
deleted.
21 Hires not
You cannot operate a high-resolution
supported sensor with this processing unit.
22 Hardware not
You cannot operate this firmware on
supported
your processing unit.
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr
A5E00475759-01
Possible Remedies
Confirming with OK causes the
parameters to be deleted,
Use a sensor that is not high-resolution
or a processing unit with a version that
supports high-resolution sensors.
Use the system update to install firmware
that is valid for your processing unit or
use a processing unit with a version that
supports this firmware version.
Diagnostics
7-9