Starting Setup Support In The Web Browser - Siemens SIMATIC Vision Sensor VS 130-2 Manual

Operator Input
5.3.1

Starting Setup Support in the Web Browser

If the connection between PC/PG and processing unit is established, you can
access the setup support by starting the Internet Explorer and entering the IP
address of the processing unit in the "Address" input box and calling it with "Enter".
The startup page of the setup support appears in the Internet Explorer:
The VS 130-2/VS 130-2vcr automatically blocks operator control on the processing
unit. The following message appears on the display of the VS 130-2/VS 130-2vcr:
"Settings controlled by Web" (depending on the mode a different text is displayed
instead of "Settings").
With "Adjust Sensor", you display the user interface of the VS 130-2/VS 130-2vcr.
If the processing unit is currently running a self-test, the "Self-test" page opens
instead of the user interface.
The index finger symbol and the "active" ">" symbols indicate which step of the
self-test is currently being performed. At the same time you will also see a text with
information on the current step in the lower part of the page. This also explains the
meaning of the buttons you can use to intervene in the self-test.
5-28
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr
A5E00475759-01