Siemens SIMATIC Vision Sensor VS 130-2 Manual page 120

Process Interface
Parameter Declaration Data type Address
DONE
OUTPUT
Error
OUTPUT
ERRCODE
OUTPUT
STATE
OUTPUT
CODE_OUT OUTPUT
LENGTH OUTPUT
6-22
(instance DB)
BOOL 22.1
BOOL 22.2
DWORD 24.0
WORD 28.0
BYTE 30.0
WORD 32.0
Default Description
setting
FALSE DONE=TRUE: Job completed
without error.
This means that the transfer
between processing unit and FB
(CPU) was successfully
completed error-free for read
jobs, (COMMAND =
W#16#0081 to 008F). In order
to find out if the DMC evaluation
was successful, you have to
evaluate the bits READ (Bit 3),
MATCH (Bit 4) and N_OK (Bit 5)
in the status byte of the
processing unit.
FALSE ERROR=TRUE: An error has
occurred.
DW#16# Error information:
00000000
•
DW#16#0000 0000:
No error
•
DW#16#0000 wxyz:
Warning
•
DW#16#0001 wxyz:
FB-internal error
•
DW#16#0002 wxyz:
Processing unit error
(refer to the error information
table at the end of this section)
W#16# 0000 Mode of the VS 130-2:
•
W#16#0000: Mode not up
to date
•
W#16#0001:
RUN (processing mode
with output of the result
string), in other words, bits
IN_OP and RDY are set in
the status byte.
•
W#16#0002:
STOP (incl. training and
adjust mode), in other
words, bit IN_OP is set in
the status byte, bit RDY,
however, is not.
•
W#16#0003:
ERROR, in other words, bit
IN_OP is not set in the
status byte
B#16#00 No. of the code currently set on
the VS 130-2
W#16# 0000 Length of the result string in
bytes
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr
A5E00475759-01