Siemens SIMATIC Vision Sensor VS 130-2 Manual page 56

Operator Input
The following table describes all the parameters of the Connect menu.
Parameter Path
Ports
Pulsetime Ports>DI/DO
Address Ports>DP
(not active, if
IP Mode =
PNIO)
(only for
VS 130-2)
Timeout Ports>DP
(not active, if
IP Mode =
PNIO)
(only for
VS 130-2)
Pulsetime Ports>DP
(not active, if
IP Mode =
PNIO)
(only for
VS 130-2)
Swap Ports>DP
(not active, if
IP Mode =
PNIO)
(only for
VS 130-2)
Devname Ports>PNIO
(not active, if
IP Mode =
PNIO)
(only for
VS 130-2)
Timeout Ports>PNIO
(not active, if
IP Mode =
PNIO)
(only for
VS 130-2)
Pulsetime Ports>PNIO
(not active, if
IP Mode =
PNIO)
(only for
VS 130-2)
5-12
Possible Default setting
Values
5 to 999 30
1 to 125 7
100 to 2000 500
5 to 999 30
S7, No S7
String (0 to 9, A VS 130-2
to Z, a to z, ".",
"-"). The string
must match the
conventions of
the domain
name system.
100 to 2000 500
5 to 999 30
Meaning
Pulse time of the digital outputs
READ, MATCH, N_OK in ms on the
DI/DO interface
Address on PROFIBUS DP
Handshake monitoring time in ms
Pulse time of the digital outputs
READ, MATCH, N_OK in ms when
output is over PROFIBUS DP
Specifies the byte order for data
types with a width of 16 bits or more:
1. S7: big endian
2. No: little endian
Name of the device on PROFINET
Note: PROFINET is not case
sensitive
Handshake monitoring time in ms
Pulse time of the digital outputs
READ, MATCH, N_OK in ms when
output is over PROFIBUS I/O
Note: For the pulse time, select a
higher value than for the update time
of the PROFINET IO system in HW
Config.
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr
A5E00475759-01