Warnings/Notes - Siemens SIMATIC Vision Sensor VS 130-2 Manual

7.2.2

Warnings/Notes

No. Signal Description
1
PROFIBUS When setting Control, Trigger, String or
Connection Result on PROFIBUS DP, no connection
failed could be established.
The settings are applied when you
acknowledge the message with OK. The
settings are not applied if you
acknowledge with ESC.
2
Cycletime Setting the Exposure to Auto is possible
must be only when Cycletime is set to > 200 ms.
> 200 ms The setting will not be adopted.
3
For Verify The Verify task can only be selected
Exposure when Exposure is set to manual and
Manual Exposure cannot be changed from
Manual when the task is set to Verify.
The setting will not be adopted.
4
String=DP The string output can only be configured
needs for PROFIBUS DP when Control is also
Control=DP configured for PROFIBUS DP and
Control cannot be changed from
PROFIBUS DP when String is configured
for PROFIBUS DP.
The setting will not be adopted.
5
Permission The security settings prevent this value
denied for ... being set in the menu of the processing
unit.
6
Restart to A device name change on PROFINET
Activate only becomes active after restarting the
processing unit.
7
Please wait The exposure is being optimized during
setup. Several image captures will be
made.
If trigger is set to "Trg. Only", there must
be a trigger for this.
8
This will delete The change to the parameter means that
all codes all codes must be retrained. All existing
trained codes are deleted.
9
TCP/IP During the self-test, the system waits for
Esc:Skip the activation of the TCP/IP connections
(If applicable, obtaining the IP address
from the DHCP server).
10 Arch/MMI
In the self-test, the system waits for the
Esc:Skip TCP/IP connection to the archiving
software to be established.
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr
A5E00475759-01
Possible Remedies
You must correct the PROFIBUS DP
parameters or activate the
communication partner.
If you want to use Exposure Auto, you
must first increase Cycletime to > 200
ms.
Change the parameter assignment.
Configure the Control parameter for DP.
Set the value over the Web user
interface for changed the security
settings of the Web user interface.
Turn the power supply for the processing
unit of an on again.
If the message does not disappear
automatically after a few seconds, check
the network connection.
With ESC, you can skip connection
establishment (or it continues in the
background).
If the message does not disappear
automatically after a few seconds, check
the connection to the archiving software.
With ESC, you can skip connection
establishment (or it continues in the
background).
Diagnostics
7-7