Siemens SIMATIC Vision Sensor VS 130-2 Manual page 48

Operator Input
The following table lists the menus of the ADJUST menu level.
Menu
STOP
Adapt
Trigger
Delay
Distort
LightSrc.
The menus of the STOP menu level are listed in the following table.
Menu
Adjust
Connect
Train
RUN
Options
Maintain
5-4
Meaning
Exits the ADJUST menu level
If you have made changes in the Adjust menu, you can save or discard them.
The processing unit changes to the STOP mode.
(only with Exposure = Manual) exposure adaptation
Trg.only
Auto (default)
Specification of a maximum speed: Time by which the trigger signal will be
delayed (identical parameter to Delay in the Options>Integrate>Trigger menu)
Default: 0 ms
Correction of the image distortion caused by the lens
Default:
•
Sensor head 6GF2 002-8DA01: 130
•
Sensor head 6GF2 002-8EA01: 50
•
Sensor head 6GF2 002-8FA01: 0
•
Sensor head 6GF2 002-8CB: 0
•
Sensor head 6GF2 002-8GB: 0
Specifies a light source (only in multilight mode)
Meaning
Changes to the setup mode
Sets global connection parameters (interfaces, integration, result string)
Train a code
Start evaluation of a code
Sets global device parameters (decoding, illumination and image capture,
diagnostics)
Delete trained codes and reset all parameters to their default values
An image is captured only on the trigger signal.
The images are acquired continuously.
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr
A5E00475759-01