Siemens SIMATIC Vision Sensor VS 130-2 Manual page 59

Parameter Path
Integrate
Source Integrate>
Trigger
String Integrate>
Trigger
(only if
Source=
TCP/RS-
232)
Delay Integrate>
Trigger
String Integrate
Result Integrate
Control Integrate
DiagImage Integrate
(only for
VS 130-2)
DiagReport Integrate
(only for
VS 130-2)
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr
A5E00475759-01
Possible Default setting
Values
Endless DI/DO
DI/DO
DP or PNIO
(only for
VS 130-2)
TCP/RS-232
ASCII M
characters
0 to 9999 ms 0 ms
DP or PNIO None
(only for
VS 130-2)
TCP/RS-232
None
DP or PNIO DI/DO
(only for
VS 130-2)
DI/DO
None
DP or PNIO DI/DO
(only for
VS 130-2)
DI/DO
None None
Arch/MMI
None None
Arch/MMI
Operator Input
Meaning
Here, you set the port over which the
trigger signal is sent to the
processing unit.
If the string specified here is sent
over the RS-232 port of an RS-232
Ethernet converter or a TCP server,
the processing unit generates a
trigger signal.
Here, you specify the time by which
the trigger signal will be delayed in
ms (Identical parameter to Delay in
the Adjust menu).
Here, you enter the port over which
the result string is output.
Here, you specify the port over which
the result bits OK, N_OK, READ,
and MATCH are output.
Here you specify the port for the
DISA, SEL0, SEL1, SEL2, SEL3,
TRN, RES, IN_OP, TRD, RDY
signals.
Here, you specify whether the
currently captured image will be sent
to a server when an error occurs.
Here, you specify whether the
corresponding data record will be
sent to a server when an error
occurs.
5-15