EBARA ESA500W Instruction Manual page 72

with the tape.
(7) Wrap the pump in a vinyl sheet.
(8) Use the eyebolts provided on the pump for slinging the pump to load and
unload. Fasten eyebolts completely and push in until flush with the seating
surface. For sling, use a wire with a length so that the slinging angle (that
is, the angled subtended by the two wires) is within 60 degrees.
DANGER Do not enter the zone underneath the suspended pump.
WARNING For lifting the pump, use only qualified operator personnel.
WARNING
(9) When options such as an interface box are attached to the pump, be
careful to avoid damage due to contact by the wire rope.
PM10U
Be sure that the wire rope and crane used for lifting the pump
are in proper order and match the weight of the pump.
To prevent unequal weight distribution, suspend the pump by
ensuring that the slinging angle remains symmetrically
centered.
In case of sling and transportation, be sure not to remain
leaning more than 10 deg against a horizontal for 5 minutes.
If not, oil leakage will occur.
60 deg
or less
Fig. 9.1 Slinging the Pump
P.59
EBARA
CORPORATION