Server Parameters - Barco TransForm A series User Manual

6.1.5 X server parameters
If you want to make changes to the graphical user interface X.11, which are not supported by the configuration
tools introduced in section
with a number of options.
On T F A there are manual pages about the Xserver available. For reading these man pages enter man
RANS ORM
Xserver in the command line:
# man Xserver
Additional options are listed in the table below:
-no_cursor_on_video
-ddc_all
-no_ddc
-DRGB_888
-new_video_layout
-noise_reduction <level>
The desired options must be entered manually each in a single line in the file:
/etc/MMTconfig/MMTServerConfig
X Server parameters that shall not be changed at a new run of the script EOSconfig can be entered between the
two lines:
# BeginSection Private
# EndSection
The file MMTServerConfig contains already lines inserted automatically by the configuration
script. Do not change these entries manually.
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
3.4.2 X.11 configuration, you can manipulate the appearance and the properties of X.11
The cursor becomes invisible, as long as it is moved over videos.
DDC detection is asked for every graphic channel. Each graphic channel
needs up to 6 seconds for detection. Therefore this should not be used as
a standard, see section
DDC detection is not done at all.
All RGB sources are digitized and transferred to the O
bpp (RGB 8:8:8) instead of the default setting with 16 bpp (RGB 5:6:5).
Restarting the X server without this option resets the default settings.
Configures in a distributed system to each video adapter its own video
channel. For usage of logical video channels please refer to section
Configuring a distributed system
Sets the noise reduction level for all video clients. Integer values in the
range from 0 to 16 can be specified. Optimal noise reduction has to con-
sider the content of the displayed source.
0 off, no noise reduction
1 most modest level of noise reduction
12 default value
16 maximum value
If the option is not set, the default value of 12 is applied.
4.8.2 DDC utility.
and 6.1.6 Advanced configuration of TransForm
______________________________________________________
6. Advanced configuration
S with 24
MNI CALER
3.4.3
A.
Table 6-2
6-9