Upgrading System Software - Barco TransForm A series User Manual

6.1.3 Upgrading system software

OmniBus configuration
All former system software on an T
No special considerations are required.
Processor configuartion
Upgrading the system software to the current release is only possible if already release 2.4 or higher is installed
on the Processor configuration.
Release 2.3 and earlier can not be upgrated to release 2.4 and higher. Instead a complete
system installation is necessary. Please note that this will delete any data from the harddisk
and that also complete configuration is necessary after the installation! Information about
system installation you find in section
Upgrade
To upgrade the system software, switch on T
OVT-2686-1. T F
RANS ORM
options. To upgrade T
RANS
Before the upgrade starts just the keyboard must be specified. Select the type of the used keyboard with the
arrow keys and confirm OK. If you press Cancel a keyboard of us type becomes installed by default.
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
F A in OmniBus configuration can be upgraded to the current version.
RANS ORM
RANS
A will boot from CD. The Welcome Screen displays a selection of installation and upgrade
F A type upgrade and press the <Enter> key.
ORM
6.1.2 Installing system software on the hard
F A and insert the installation CD TransForm A - system disc
ORM
6. Advanced configuration
drive.
______________________________________________________
Figure 6-8
Figure 6-9
6-6