Table of Contents
Advertisement
6.1.2 Installing system software on the hard drive
Usually T
F
A comes with preinstalled system software. In case you want to reinstall the system software
RANS
ORM
or install a new hard disk, please follow the instructions in this section.
Installation
Switch on T
F
A and insert the system CD. T
RANS
ORM
selection of installation options. Select the type for your installation and enter the required keyword.
•
T
F
A in eXtended safety boot mode:
RANS
ORM
press the <Enter> key
•
T
F
A in normal boot mode:
RANS
ORM
type eosn and press the <Enter> key
•
Upgrade T
F
A:
RANS
ORM
please see section
6.1.3 Upgrading system
After selecting the type of your installation, you are asked if you really want to delete the partitions and install
the system software. If you want to skip the installation you can press <alt><ctrl><delete> simultane-
ously. If you want to install you must confirm with y <cr> and the T
installed.
When the system software is installed just the keyboard and the IP address of the primary network card must be
specified. Select the type of the used keyboard with the arrow keys and confirm OK. If you press Cancel a key-
board of us type becomes installed by default.
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
F
A will boot from CD. The Welcome Screen displays a
RANS
ORM
software!
6. Advanced configuration
F
A operating system is getting
RANS
ORM
______________________________________________________
Figure 6-1
Figure 6-2
6-3
Advertisement
Table of Contents
