Graphic Cards - Barco TransForm A series User Manual

3.2.5 Graphic cards

The DDC capable UGX and AGX G
mode) or for connecting Barco projection modules (digital mode) to T
the board they can easily be switched between analog and digital mode.
For T F A systems with digital output and video or RGB insertions the output of the graphic cards is led
RANS ORM
over to O S and then connected to the display device. Please refer to section
MNI CALERS
Connectors
The UGX G C provides two Dual-DVI connectors to connect four display devices. For digital output, resolu-
RAPHIC ARD
tions up to 1920x1200 can be processed.
DDC capable display devices must be connected to the graphic cards before TransForm A is
switched on. If they are connected afterwards, TransForm A will not be able to detect them!
Specifications
For detailed technical specifications of the graphic cards please refer to section
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
C provide the facility for connecting CRT monitors or projectors (analog
RAPHIC ARDS
port 0/1 out
port 2/3 out
LED port 2/3
F A. By means of a rotary switch on
RANS ORM
3.2.6 OmniScaler.
Ports of UGX G
7.1 Technical data.
_____________________________________________________
3. Getting started
Figure 3-20
C
RAPHIC ARD
3-16