Analyzer Diagnostics Menu Structure - JLG E450A Service And Maintenance Manual

SECTION 6 - JLG CONTROL SYSTEM

Analyzer Diagnostics Menu Structure

In the following structure descriptions, an intended item is
selected by pressing ENTER
steps back to the next outer level. The LEFT
Diagnostics Submenu
(Displayed on Analyzer
st
1 Line)
DRIVE/STEER [Platform DRIVE DEMAND
Mode =True]
DRIVE OUTPUT
DRIVE MODE
STEER DEMAND
STEER OUTPUT
STEER PRTY VLV
STEER SENSOR
STEER SENSOR
DRV ORIENT MODE
DRV ORIENT STATE
DRV ORNT OVR SW
BOOM FUNCTIONS SWING DEMAND
SWING OUTPUT
SWING ASSIST
LIFT OUTPUT
LIFT BYPAS
TELE DEMAND
TELE OUTPUT
JIB LIFT DEMAND
JIB LIFT OUTPUT
JIB SWING DEMAND
JIB SWING OUTPUT
6-40
; pressing ESCAPE
or RIGHT
Table 6-9. DIAGNOSTICS - Menu Descriptions
Parameter
(Displayed on
st
Analyzer 1 Line)
FORWARD/REVERSE XXX%
FORWARD/REVERSE XXX%
MAX SPEED/REDUCED SPEED
LEFT/RIGHT XXX%
LEFT/RIGHT XXX%
XXX%
VOLTAGE XX.XXV
ANGLE XX.XDEG
INLINE/SWUNG
CONFIRMED/REQUIRED
CLOSED/OPEN
LEFT/RIGHT XXX%
LEFT/RIGHT XXX%
ON/OFF
UP/DOWN XXX%
ON/OFF
IN/OUT XXX%/CREEP
IN/OUT/OFF
UP/DOWN XXX%/CREEP
UP/OFF/DOWN XXX%
LEFT/RIGHT XXX%/CREEP
LEFT/RIGHT XXX%
arrow keys move between items in the same level. The
UP or DOWN
Parameter Value
(Displayed on
nd
Analyzer 2 Line)
Direction and calibrated Control System Command percentage
UGM direction and output speed command
Drive Mode status
Direction and percentage of input command from Drive/Steer Joystick
UGM directional valve output status
Steer priority bypass valve
[Machine SetUp -> E450 or E400N]
Steer sensor raw voltage reported by MTM
Steer sensor angle reported by MTM
State of DOS switch (prox energized when in line to close normally
open contacts)
InLine and DOS Active = Confirmed
State of Drive Orientation Override Switch
Direction and percentage of input command from Swing Joystick or
Ground %
Direction and valve PWM output percentage
Status of swing restriction bypass valve
[Machine SetUp -> Model = E450 or E400N]
Direction and valve PWM output percentage
Status of Lift Bypass Valve
[Machine SetUP -> Model = E450 or E400N]
Direction and percentage of input command (or CREEP if applicable)
from Function Speed Pot or Ground%
Direction/state of Tele directional valve
Direction and percentage of input command (or CREEP if applicable)
from Function Speed Pot or Ground%
[Machine SetUP -> JIB -> YES]
Direction for Up, but % command for Down
[Machine SetUP -> JIB -> YES]
Direction and percentage of input command (or CREEP if applicable)
from Function Speed Pot or Ground%
[Machine SetUP -> JIB SWING -> YES]
Direction for Left, but % command for Right
[Machine SetUP -> JIB SWING -> YES]
arrow keys alter a value if allowed.
Description
3121714