Machine Setup; Level Vehicle Description - JLG E450A Service And Maintenance Manual

Machine Setup

When a machine digit item is selected, press the UP
DOWN arrow keys to adjust its value, for example:
GROUND ALARM:
LIFT DOWN
The effect of the machine digit value is displayed along with
its value. The above display would be selected if the machine
was equipped with a ground alarm and you wanted it to
sound when driving. There are certain settings allowed to
install optional features or select the machine model.
When selection the machine model to match the size of the
machine, the personality settings will all default to the factory
recommended setting.
NOTE: Refer to Table 6-4, Personality Ranges/Defaults, and Table
6-6, Machine Setup Descriptions in this Service Manual for
the recommended factory settings.
NOTE: Password 33271 will give you access to Service Access,
which will permit you to change all machine personality
settings.
There is a setting that JLG strongly recommends that you do
not change. This setting is so noted below:
ELEVATION CUTBACK
3121714
CHANGING THIS SETTING MAY ADVERSELY AFFECT THE PERFORMANCE OF
YOUR MACHINE.
or
ITS IS A GOOD PRACTICE TO AVOID PRESSURE-WASHING ELECTRICAL/ELEC-
TRONIC COMPONENTS. SHOULD PRESSURE-WASHING BE UTILIZED TO WASH
AREAS CONTAINING ELECTRICAL/ELECTRONIC COMPONENTS, JLG INDUSTRIES
INC. RECOMMENDS A MAXIMUM PRESSURE OF 750 PSI (52 BAR) AT A MINI-
MUM DISTANCE OF 12 INCHES (30.5CM) AWAY FROM THESE COMPONENTS. IF
ELECTRICAL/ELECTRONIC COMPONENTS ARE SPRAYED, SPRAYING MUST NOT
BE DIRECT AND BE FOR BRIEF TIME PERIODS TO AVOID HEAVY SATURATION.

Level Vehicle Description

A NEW TILT MODULE WILL ACT AS IF IT IS TILTED ALL OF THE TIME UNTIL THE
FOLLOWING PROCEDURE IS PERFORMED.
DO NOT LEVEL VEHICLE EXCEPT ON A LEVEL SURFACE.
LEVEL VEHICLE
YES:ENTER, NO:ESC
Not available at password level 2 ENTER confirms that vehicle
is currently level, and zeroes the tilt sensor measurements
SECTION 6 - JLG CONTROL SYSTEM
6-5