Input Carrier Disassembly - JLG E450A Service And Maintenance Manual

SECTION 3 - CHASSIS & TURNTABLE

Input Carrier Disassembly

NOTE: Refer to Figure 3-15., Input Carrier.
1. Using a 1/8" diameter punch, drive the Roll Pin (4G) into
the Planet Shaft (3E) until it bottoms against the Carrier
(3A).
2. Using a soft face hammer, tap the Planet Shaft (3E) out
of the Carrier (3A).
3. Using a 1/8" diameter punch, drive the Roll Pin (4G) out
of the Planet Shaft (3E).
3-18
NOTE: The Roll Pins (4G} should not be reused when reassembling
4. Slide the Planet Gear (3F) and the two Thrust Washers
5. Remove the 14 needle Bearings (3C} from the bore of
6. Repeat steps 1 through 5 for each of the two remaining
3A. Carrier 3E. Planet Shaft
3B. Thrust Washer 3F. Planet Gear
3C. Needle Bearing 4G. Roll Pin
Figure 3-15. Input Carrier
the unit.
(3B) out of the Carrier (3A).
the Planet Gear (3F).
planet gears.
3121714