JLG E450A Service And Maintenance Manual page 326

SECTION 6 - JLG CONTROL SYSTEM
Configuration Digit
LOAD SYSTEM:
11*
* Only visible under certain
market selections.
* Certain market selections
will limit load system
options or alter default set-
ting.
FUNCTION CUTOUT:
12*
* Only visible under certain
market selections.
* Certain market selections
will limit load system
options or alter default set-
ting.
DISPLAY UNITS:
13
ALERT BECON:
14*
* Only visible if Skyguard is
selected.
TEMP OUTPUT:
15*
* Certain market selection
will display temp cutout
options.
WHEEL DRIVE:
16*
* Only visible if E600 model
is selected.
6-10
Table 6-2. Machine Configuration Programming Information
Number
1 NO: No load sensor installed.
2 WARN ONLY: Functions in creep, overload lamp lit, platform alarm beeps(5 sec ON, 2 sec OFF).
3 CUTOUT PLATFORM: All functions cutout, overload lamp lit, platform alarm beeps(5 SEC ON, 2 SEC OFF).
4 CUTOUT ALL: All functions cutout, flash overload light (500 mS on, 500 mS off), platform alarm beeps(5
SEC ON, 2 SEC OFF).
1 NO: No drive cutout.
2 BOOM CUTOUT: Boom function cutout while driving above elevation.
3 DRIVE CUTOUT: Drive and steer cutout above elevation.
1 METRIC
2 IMPERIAL
1 OFF FOR CREEP.
2 20 FPM FOR CREEP.
1 NO:
2 YES: Low temp cutout system is installed.
1 4WD:Front wheel assist (4WD) system is installed
2 2WD: Front wheel assist (4WD) system is not installed.
Description
Default
Number
1
1
1
CSA, CE, AUS,
JAPAN, GB
2
ANSI USA,
ANSI Export
1
1
2
3121714