JLG E450A Service And Maintenance Manual page 357

Diagnostics Submenu
(Displayed on Analyzer
st
1 Line)
PLAT LVL DEMAND
PLAT LVL OUTPUT
PLAT ROT DEMAND
PLAT ROT OUTPUT
PUMP SPEED CMD
PUMP SPEED FDBK
PUMP CURRENT
PUMP ENABL
PUMP OP MODE
FUNCTION SPEED
[Platform Mode = True]
CREEP SW
[Platform Mode = True]
CREEP MODE
FLOW CONTRL VLV
SYSTEM MAIN CONTACTOR
MAIN CONT VOTE
CHASSIS TILT
CHASSIS TILT
CHASSIS TILT
UGM AMBIENT TEMP
LOW AMBIENT TEMP
LOW TEMPERATURE
MSSO
3121714
Table 6-9. DIAGNOSTICS - Menu Descriptions
Parameter
(Displayed on
st
Analyzer 1 Line)
UP/DOWN XXX%/CREEP
UP/DOWN XXX%
LEFT/RIGHT XXX%/CREEP
LEFT/RIGHT XXX%
XXX%
XXX%
FDBK: XXXA
ON/OFF
OFF/RUNNING
SETTING: XXX%
OPEN/CLOSED
ON/OFF
XXX%
ENABLED/DISABLED
ENABLED/DISABLED
XX.XDEG
X-AXIS: XX.XDEG
Y-AXIS: XX.XDEG
XXXC/XXXF
XXXC/XXXF
CUTOUT: ACTIVE/INACTIVE/FAULTY
ACTIVE/INACTIVE
Parameter Value
(Displayed on
nd
Analyzer 2 Line)
Direction and percentage of input command (or CREEP if applicable)
from Function Speed Pot or Ground%
Direction/state of Level directional valve
Direction and percentage of input command (or CREEP if applicable)
from Function Speed Pot or Ground%
Direction/state of Rotate directional valve
UGM pump command value: 0-100%
Pump PWM reported from MTM
Pump current reported from MTM
UGM pump enable bit status
Pump status from MTM
Displays the percentage demand from the Function Speed
Potentiometer.
Status of Creep Switch Input
Displays status of Creep Mode
Duty cycle of flow control proportional valve
Status of Main Contactor reported by Zapi module
Status of Main Contactor voting relay by UGM
Combined X/Y Absolute Angle
X Angle with respect to sign
Y Angle with respect to sign
Ambient Temperature Sensor Reading from on-board UGM Sensor
Low Temp Cutout Sensor Ambient Temperature sensor Reading
[MACHINE SETUP ' TEMP CUTOUT = YES
Status of Low Temperature Cutout; Only displayed if
MACHINE SETUP
Status of MSSO
[MACHINE SETUP'MARKET=CE and Operating Mode=Ground]
SECTION 6 - JLG CONTROL SYSTEM
Description

TEMP CUTOUT = YES
6-41