Replacing Moving End Brackets - JLG E450A Service And Maintenance Manual

Replacing Moving End Brackets

1. Remove existing pins and center rivet. Remove the rivet
the same way as shown in the link removal instructions.
Repeat on other bracket if replacing it as well.
MOVE THE CABLES/HOSES OUT OF THE WAY DURING THE GRINDING PROCESS
TO PROTECT THEM. KEEP THE HOSES AND CABLES COVERED TO PREVENT ANY
DEBRIS FROM GETTING ON THEM.
3121714
SECTION 4 - BOOM & PLATFORM
2. Take new bracket and install center pin with snap ring.
4-39