Switchport Priority Default - SMC Networks SMC TigerStack III SMC6824M Management Manual

P C
RIORITY OMMANDS
Command Usage
WRR controls bandwidth sharing at the egress port by defining
scheduling weights.
Example
The following example shows how to assign WRR weights of 1, 3, 5 and 7 to
the CoS priority queues 0, 1, 2 and 3:
Console(config)#queue bandwidth 1 3 5 7
Console(config)#
Related Commands
show queue bandwidth (4-259)

switchport priority default

This command sets a priority for incoming untagged frames. Use the no
form to restore the default value.
Syntax
switchport priority default default-priority-id
no switchport priority default
default-priority-id - The priority number for untagged ingress traffic.
The priority is a number from 0 to 7. Seven is the highest priority.
Default Setting
The priority is not set, and the default value for untagged frames received
on the interface is zero.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The precedence for priority mapping is IP Port, IP Precedence or IP
DSCP, and default switchport priority.
• The default priority applies for an untagged frame received on a port set
to accept all frame types (i.e, receives both untagged and tagged frames).
This priority does not apply to IEEE 802.1Q VLAN tagged frames. If
4-256