Figure 3-24 Configuring Snmp Trap Managers - SMC Networks SMC TigerStack III SMC6824M Management Manual

C
ONFIGURING THE
- Retry times – The maximum number of times to resend an inform
message if the recipient does not acknowledge receipt. (Range: 0-255;
Default: 3)
• Enable Authentication Traps
specified IP trap managers whenever authentication of an SNMP request
fails. (Default: Enabled)
• Enable Link-up and Link-down Traps
message whenever a port link is established or broken. (Default: Enabled)
Web – Click SNMP, Configuration. Enter the IP address and community
string for each management station that will receive trap messages, specify
the UDP port, trap version, trap security level (for v3 clients), trap inform
settings (for v2c/v3 clients), and then click Add. Select the trap types
required using the check boxes for Authentication and Link-up/down
traps, and then click Apply.
CLI – This example adds a trap manager and enables authentication traps.
Console(config)#snmp-server host 10.1.19.23 inform private
version 2c udp-port 160
Console(config)#snmp-server enable traps authentication
Console(config)#
3. These are legacy notifications and therefore when used for SNMP Version 3 hosts, they must be enabled
in conjunction with the corresponding entries in the Notification View (page 3-61).
3-52
S
WITCH

Figure 3-24 Configuring SNMP Trap Managers

3
– Issues a notification message to
– Issues a notification
3
4-156
4-159