Ip Igmp Snooping Query-Max-Response-Time - SMC Networks SMC TigerStack III SMC6824M Management Manual

M F
ULTICAST ILTERING

ip igmp snooping query-max-response-time

This command configures the snooping report delay. Use the no form of this
command to restore the default.
Syntax
ip igmp snooping query-max-response-time seconds
no ip igmp snooping query-max-response-time
seconds - The report delay advertised in IGMP queries. (Range: 5-25)
Default Setting
10 seconds
Command Mode
Global Configuration
Command Usage
• The switch must be using IGMPv2 for this command to take effect.
• This command defines the time after a query, during which a response is
expected from a multicast client. If a querier has sent a number of queries
defined by the ip igmp snooping query-count, but a client has not
responded, a countdown timer is started using an initial value set by this
command. If the countdown finishes, and the client still has not
responded, then that client is considered to have left the multicast group.
Example
The following shows how to configure the maximum response time to
20 seconds:
Console(config)#ip igmp snooping query-max-response-time 20
Console(config)#
Related Commands
ip igmp snooping version (4-271)
ip igmp snooping query-max-response-time (4-276)
4-276
C
OMMANDS