Ip Interface Commands; Ip Address; Table 4-73 Ip Interface Command Syntax - SMC Networks SMC TigerStack III SMC6824M Management Manual

IP I C
NTERFACE

IP Interface Commands

An IP addresses may be used for management access to the switch over your
network. The IP address for this switch is obtained via DHCP by default.
You can manually configure a specific IP address, or direct the device to
obtain an address from a BOOTP or DHCP server when it is powered on.
You may also need to a establish a default gateway between this device and
management stations or other devices that exist on another network
segment.
Command

ip address

ip
default-gateway
ip dhcp restart
show ip interface Displays the IP settings for this device
show ip redirects Displays the default gateway configured for this
ping
ip address
This command sets the IP address for the currently selected VLAN interface.
Use the no form to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.
4-280
OMMANDS

Table 4-73 IP Interface Command Syntax

Function
Sets the IP address for the current interface
Defines the default gateway through which an
in-band management station can reach this device
Submits a BOOTP or DCHP client request
device
Sends ICMP echo request packets to another
node on the network
Mode Page
IC 4-280
GC 4-282
PE 4-282
PE 4-283
PE 4-284
NE, 4-284
PE