Lacp Port-Priority - SMC Networks SMC TigerStack III SMC6824M Management Manual

Example
Console(config)#interface port channel 1
Console(config-if)#lacp admin-key 3
Console(config-if)#

lacp port-priority

This command configures LACP port priority. Use the no form to restore
the default setting.
Syntax
lacp {actor | partner} port-priority priority
no lacp {actor | partner} port-priority
• actor - The local side an aggregate link.
• partner - The remote side of an aggregate link.
• priority - LACP port priority is used to select a backup link.
(Range: 0-65535)
Default Setting
32768
Command Mode
Interface Configuration (Ethernet)
Command Usage
• Setting a lower value indicates a higher effective priority.
• If an active port link goes down, the backup port with the highest priority
is selected to replace the downed link. However, if two or more ports
have the same LACP port priority, the port with the lowest physical port
number will be selected as the backup port.
• Once the remote side of a link has been established, LACP operational
settings are already in use on that side. Configuring LACP settings for the
partner only applies to its administrative state, not its operational state,
and will only take effect the next time an aggregate link is established
with the partner.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#lacp actor port-priority 128
C L
OMMAND INE
I
NTERFACE
4-195