SMC Networks SMC TigerStack III SMC6824M Management Manual page 375

Command Usage
• The system prompts for data required to complete the copy command.
• The destination file name should not contain slashes (\ or /), the leading
letter of the file name should not be a period (.), and the maximum length
for file names on the TFTP server is 127 characters or 31 characters for
files on the switch. (Valid characters: A-Z, a-z, 0-9, ".", "-", "_")
• Due to the size limit of the flash memory, the switch supports only two
operation code files and three configuration files (including the factory
defaults file).
• You can use "Factory_Default_Config.cfg" as the source to copy from
the factory default configuration file, but you cannot use it as the
destination.
• To replace the startup configuration, you must use startup-config as the
destination.
• Use the copy file unit command to copy a local file to another switch in
the stack. Use the copy unit file command to copy a file from another
switch in the stack.
• The Boot ROM and Loader cannot be uploaded or downloaded from
the TFTP server. You must follow the instructions in the release notes
for new firmware, or contact your distributor for help.
• For information on specifying an https-certificate, see "Replacing the
Default Secure-site Certificate" on page 3-77. For information on
configuring the switch to use HTTPS/SSL for a secure connection, see "ip
http secure-server" on page 4-41.
• When updating the PoE controller (to the SMC6824MPE and
SMC6826MPE), first copy the PD controller file from a TFTP server to
the switch's file system (copy file tftp, and select "PD_Controller"),
then copy this file to the controller (copy file controller, and select
"PoE").
• When specifying the file type "PD_Controller" or "PoE" for copy
operations (on the SMC6824MPE and SMC6826MPE), file types other
than PoE controller may be downloaded, but will not adversely affect the
system.
C L
OMMAND INE
I
NTERFACE
4-83