SMC Networks SMC TigerStack III SMC6824M Management Manual page 213

• Forward Delay – The maximum time (in seconds) the root device will
wait before changing states (i.e., discarding to learning to forwarding).
This delay is required because every device must receive information
about topology changes before it starts to forward frames. In addition,
each port needs time to listen for conflicting information that would
make it return to a discarding state; otherwise, temporary data loops
might result.
• Designated Root – The priority and MAC address of the device in the
Spanning Tree that this switch has accepted as the root device.
- Root Port – The number of the port on this switch that is closest to
the root. This switch communicates with the root device through this
port. If there is no root port, then this switch has been accepted as the
root device of the Spanning Tree network.
- Root Path Cost – The path cost from the root port on this switch to
the root device.
• Configuration Changes – The number of times the Spanning Tree has
been reconfigured.
• Last Topology Change – Time since the Spanning Tree was last
reconfigured.
These additional parameters are only displayed for the CLI:
• Spanning tree mode – Specifies the type of spanning tree used on this
switch:
- STP: Spanning Tree Protocol (IEEE 802.1D)
- RSTP: Rapid Spanning Tree (IEEE 802.1w)
- MSTP: Multiple Spanning Tree (IEEE 802.1s)
• Spanning tree backup root – Automatically lowers the switch's bridge
priority by 4096 if it loses contact with the current root device. To
succeed, the switch must have a direct connection to current root bridge,
and its adjusted bridge priority must be higher (i.e., a numerically lower
value) than all the other bridges in the spanning tree.
• Instance – Instance identifier of this spanning tree. (This is always 0 for
the CIST.)
• VLANs configuration – VLANs assigned to the CIST.
S T
PANNING REE
A C
LGORITHM ONFIGURATION
3-157