Map Ip Port (Global Configuration) - SMC Networks SMC TigerStack III SMC6824M Management Manual

Command
map access-list mac
show map ip port
show map ip
precedence
show map ip dscp
show map access-list
ip
show map access-list
mac

map ip port (Global Configuration)

This command enables IP port mapping (i.e., class of service mapping for
TCP/UDP sockets). Use the no form to disable IP port mapping.
Syntax
[no] map ip port
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The precedence for priority mapping is IP Port, IP Precedence or IP
DSCP, and default switchport priority.
Example
The following example shows how to enable TCP/UDP port mapping
globally:
Console(config)#map ip port
Console(config)#
Table 4-66 Priority Commands (Layer 3 and 4)
Function
Sets the CoS value and corresponding output
queue for packets matching an ACL rule
Shows the IP port map
Shows the IP precedence map
Shows the IP DSCP map
Shows CoS value mapped to an access list for
an interface
Shows CoS value mapped to an access list for
an interface
C L
OMMAND INE
I
NTERFACE
Mode Page
IC 4-147
PE 4-266
PE 4-267
PE 4-268
PE 4-136
PE 4-148
4-261