Web – Click System, Log, System Logs. Specify the System Log Status, set
the level of event messages to be logged to RAM and flash memory, and
then click Apply.
CLI – Enable system logging and then specify the level of messages to be
logged to RAM and flash memory. Use the show logging command to
display the current settings.
Console(config)#logging on
Console(config)#logging history ram 6
Console(config)#
Console#show logging ram
Syslog logging:
History logging in RAM: level informational
Console#
Remote Log Configuration
The Remote Logs page allows you to configure the logging of messages
that are sent to syslog servers. You can also limit the error messages sent to
only those messages below a specified level.
Command Attributes
• Remote Log Status – Enables/disables the logging of debug or error
messages to the remote logging process. (Default: Disabled)
• Logging Facility – Sets the facility type for remote logging of syslog
messages. There are eight facility types specified by values of 16 to 23.
The facility type is used by the syslog server to dispatch log messages to
an appropriate service.
Figure 3-15 System Logs
Enabled
B
C
ASIC
ONFIGURATION
4-57
4-57
4-61
3-37