Queue Mode; Table 4-64 Priority Commands (Layer 2) - SMC Networks SMC TigerStack III SMC6824M Management Manual

P C
RIORITY OMMANDS
Priority Commands (Layer 2)
Command

queue mode

queue bandwidth
switchport priority
default
queue cos map
show queue mode
show queue
bandwidth
show queue cos-map Shows the class-of-service map
show interfaces
switchport
queue mode
This command sets the queue mode to strict priority or Weighted
Round-Robin (WRR) for the class of service (CoS) priority queues. Use the
no form to restore the default value.
Syntax
queue mode {strict | wrr}
no queue mode
• strict - Services the egress queues in sequential order, transmitting all
traffic in the higher priority queues before servicing lower priority
queues.
• wrr - Weighted Round-Robin shares bandwidth at the egress ports by
using scheduling weights 1, 4, 16 and 64 for queues 0 - 3 respectively.
Default Setting
Weighted Round Robin
4-254

Table 4-64 Priority Commands (Layer 2)

Function
Sets the queue mode to strict priority or
Weighted Round-Robin (WRR)
Assigns round-robin weights to the priority
queues
Sets a port priority for incoming untagged
frames
Assigns class-of-service values to the priority
queues
Shows the current queue mode
Shows round-robin weights assigned to the
priority queues
Displays the administrative and operational
status of an interface
Mode Page
GC 4-254
GC 4-255
IC 4-255
IC 4-257
PE 4-259
PE 4-259
PE 4-260
PE 4-182